User Manual Download

The Yaesu FT-1000D was designed with extensive surface-mount component technology which allowed six microprocessors and five Direct Digital Synthesizers to be harmoniously integrated with a simple operator interface into a highly reliable full-featured HF application. The quad conversion (triple for FM) receiver covers 100 kHz to 30 MHz. With MH-1C8 hand mic.

You can download the manual for the Yaesu FT-1000MP here.

FT-1000MP-Roofing-Filter-Manual-rev.pdf
FT-1000 Radio Settings

FT-1000 mark-v service manual.pdf
FT-1000 Operating Manual.pdf
FT-1000_ARRL_Test-result_report.pdf
FT-1000_Manual.pdf
FT-1000MP Operating Manual.pdf
FT-1000MP French Manual.pdf
FT-1000MP MARK-V Operating Manual.pdf
FT-1000MP Operating Manual germ.pdf
FT-1000MP_Schematic.zip
FT-1000MP_Tech_overview.pdf
FT-1000MP_Technical_Supplement.pdf
FT-1000MP-Mark V_Technical_Overview.pdf
FT-1000MP-Mark-V_Testbericht.pdf

The Yaesu VX-8R HT provides a full 5 watts FM on 50/144/430 MHz plus 1.5 watts on 222 MHz. It supports Bluetooth® hands-free operation with the optional BU-1 and BH-1 or BH-2 accessories. There is also an optional GPS unit and antenna with loads of features.

This radio supports APRS 1200/9600 bps data communication (B band only). Like the VX7R, the VX8R is submersible and meets IPX57 specifications (3 feet for minimum of 30 minutes). A powerful 7.4 V 1100 mAh Lithium Ion battery is included. This HT is small, intuitive to operate only 2.36 x 3.74 x 0.92 inches (thinner than VX-7R).

It supports simultaneous independent 2-signal dual receive function with both V + V or U + U. It has weather band receive with Weather Alert. A barometric sensor is included. You can even operate Amateur radio while receiving FM broadcasts!

The receive coverage is wider than VX-7R it replaces, with an independent AM/FM broadcast receiver circuit. The dot matrix LCD display provides Memory tag up to a maximum of 16 characters. You even get a high-resolution Spectrum Analyzer with ±60 channels indication with wave monitoring of received/modulated signal! And of course DCS and CTCSS encode and decode is standard.

You can get the user manual for the VX-8R here.

The Yaesu FT-2000 is a full sized man’s rig with great sounding audio. One can listen to this radio for hours on end without it wearing you down. The ability to upgrade firmware in this radio is a big plus. The DMU also adds some great features, especially if you’re married to the band scope, you can get a nice, large, flat screen LCD to view it on.

The FT-2000 provides a full 100 Watts of power output (AM: 25 W) on the 160-6 Meter Amateur bands, and the U.S. version includes a special memory bank containing the five 60-meter channels, as well. Continuous receiver coverage from 30 kHz to 60 MHz is provided. Note: frequency coverage may differ in your country.

Download the FT-2000 manual.

Successor of the very popular FT-1000MP (Mark-V/Field). RF and LF scope. High dynamic range front end. 6 KHz and 12 KHz Roofing Filters. IF-DSP. Sub receiver. Flexible Connection Points for RTTY, SSTV, PSK31, JT65 (EME) and other Digital Modes; VOX (Automatic voice-operated TX/RX control); All mode Squelch; FM Mode: 50-Tone CTCSS Encode/Decode System; Band-Specific Repeater Shifts for 29/50 MHz FM; Wide/Narrow modes for AM and FM; Flexible, easy-to-use VFO/Memory command selections: A>B, A=B, V/M, M>A, A>M; Memory Channel Offset Tuning (MT); Versatile Scanning Capability; Versatile Menu Mode for customization of setup and features; Transverter Jack; Constant-level rear-panel sound recording jack; Comprehensive external RS-232C computer control (CAT) protocol; Optional FH-2 Keypad provides ease of control for CW or Voice Messages and Receiver Loop recording.